IPv4 configuration

  • Re: IPv4 Configuration

    Hi. I have just connected my AmpliFi WAN port to the cable modem and getting above failure. No Internet access. Problem did not occur on previous Tilgin router.

  • Hello @ulrik-engemann-rasmussen, AmpliFi in most cases will need to be fully booted before powering on the modem, and not doing so can cause this error. Please try these steps:

    • Connect WAN cable between modem and AmpliFi & power down both units>>Power on AmpliFi>>Once AmpliFi screen prompts to Plug in cable, power on the modem

    Please let me know if you are still experiencing issues after this.
    As a side note, some ISP's require that you provide them with the routers MAC ID.

Log in to reply

Looks like your connection to AmpliFi was lost, please wait while we try to reconnect.