Why is my amplifi using different MAC after every reboot
Norbert Kraus last edited by
After every reboot there is another MAC address used. This is absolute frustrating, because then my static lease is not working. And it is also not possible to set a static IP Address.
Derek Saville last edited by
Hi @norbert-kraus - It has been reported that some routers alternate MAC addresses between the WAN and the LAN side
In the app if you select your router and under SETTINGS select ABOUT you will find the WAN & LAN MAC's at the top of the list
It is likely that your router is alternating between these two and it is very frustrating.
If so, you can set up two different static IP addresses based on these MAC's, but then you have to change routing rules when the MAC flips
Which firmware release are you using?
Have you performed a Factory Reset?
It may help