Amplifi Alien mesh using existing backbone
-
I have a 10g layer 2 network between three buildings and a dedicated Opnsense router/firewall already in place. Is it possible to put three alien units into a mesh and tell them to use ethernet as their uplink in a bridge configuration? This would be similar to three unifi aps connected to the same layer 2 network.
-
@stephanie-sunshine AmpliFi Alien could be configured in bridge mode, all independently. If the link was direct, they could also be configured as a mesh with the primary in bridge mode and the others with ethernet backhaul enabled.
-
Thank you for the prompt reply!
