Adding back existing meshpoint
Chris Wensel last edited by
I have an Amplifi HD with two mesh points. but one of them no longer shows as connected. I've tried the reset, but the device isn't discovered by the app or hardware. no is it seen when i try to 'add a standalone mesh point'.
the lights do come on and are blinking from the middle out.
the app clearly shows it offline.
fwiw, i did just notice a wifi ssid named SETUP.
Derek Saville last edited by
Hi @Chris-Wensel - unfortunately if any device from a kit has been reset, then the whole kit needs to be reset in the correct order and then setup again, so that might be the problem
There is a support article here...