Gigabit Speeds with Comcast XFINITY
Updated to 2.6.1 with Hardware NAT enabled and I'm only getting ~500 Mbps (wired). Which is about half of the ~950 Mbps when the Amplifi is only on bridge mode with another router.
Any suggestions on troubleshooting? If I understood correctly, Hardware NAT should have gotten me closer to the actual gigabit speeds, but doesn't seem to have had any affect in my situation.
Provider: Comcast XFINITY
Firmware Version: 2.6.1
@ubnt-gunars Just did, thanks for the quick reply!
Update from talking to support:
- Hardware NAT does not support IPv6 (Comcast's speedtest defaults to IPv6).
- Hardware NAT does not support fragmented packets.
@mark-collao looks like hardware NAT just isn't applied in your case. Any way you can switch to IPv4?